Arctic Cat

SLP Runners are the only recommended runners for SLP ULTRA-LITE™ Skis. They are shaped properly to match the SLP patented Rocker Keel™ design for best performance and dependability. When considering a runner for your SLP ULTRA-LITE™ Skis, keep in mind that a 6" carbide runner will corner much like 8-10" of carbide on a conventional ski. 6" carbide is the maximum length recommended. Runners Sold Per Pair.

Long-Life Carbide: These durable runners have 4 inches of 75° carbide including wear pads front and rear with hardweld filler in non-carbide areas on 7/16" host bar. The ULTRA-LITE Skis™ keel design is so effective, less carbide length can be used than the flat-keel skis with better results. 

Aggressive Trail & Racing Carbide: These aggressive runners use 6 inches of 60° carbide including wear pads front and rear with hardweld filler in non-carbide areas on 7/16" host bar. The ULTRA-LITE Skis™ keel design is so effective, less carbide length can be used than flat-keel skis with better results. Learn More

SLT (Straight Line Tracking) Ski™ bottoms are sold per each. Learn More

Loops for Powder Pro™, Tri-Keel™ and SLT Skis™ are sold per each. Learn More

Powder Pro™ Ski bottoms are sold per each. Learn More

DURAFLEX™ are a cable type ice scratcher that bolt to the slide rail easily and feature replaceable carbide tip wear points. The flexible cable design allows the sled to be run in reverse without damaging the ice scratcher. Learn More

The Power Commander V fuel controller gives you the ability to use a pre-programmed SLP map or to create a custom map of your own. Some PCV models also allow ignition timing control capabilities that provide a good horsepower improvement over just controlling fuel alone. SLP has maps for most popular SLP engine configurations. Learn More

Runners for SLP Straight Line Tracking (SLT)™, Powder Pro™, MoHawk Skis™ SLP runners are manufactured from high strength steel with hardweld surface leading into the carbide and also on the trailing edge for excellent durability. They are made to precise dimensions for a direct match with your SLP skis. Sold per pair Learn More

for Powder Pro II™, SLT II™, Tri-Keel™ and MoHawk Skis™, Sold per each (2 required to complete a set of skis) Learn More

This new vent kit provides 30% more airflow in the under-hood area of the Arctic Cat 6000/8000 or Yamaha Mountain Max models. It utilizes strategically placed vents in the shock tower (clutch side only), and the side panel rear and upper areas to promote cooler under-hood temperatures to keep your engine and clutches running at their peak potential. Instruction Sheets:
32-647 32-648 32-650 Learn More