your snowadventuresSTARThere

Raising your ProTaper bars on a Polaris sled used to be a challenge – until now. These kits include the riser block and replacement bolts which work with the stock one piece top clamp. Note: The maximum height you can raise your bars without having to extend your cables will vary depending on which height ProTaper bars you have. Verify cable free-play length before purchasing riser. Learn More

These high-performance rollers provide increased roller life. Manufactured from Torlon®, these rollers are extremely tough by design.Sold per each. Also works with Polaris TSS-21 models. Learn More

These springs offer more variety of pre-load and final rates than stock, providing adjustments for better backshift and less sensitivity to changes in elevation and snow conditions. Inquire for a recommendation specific to your combination, riding style and elevation. Sold per each. Learn More

These O-Rings are for Polaris XLT/XCR 580/600 models with SLP Billet Heads. Sold per each. Learn More

One of the most critical parts in your fueling system is the injector. Over time with normal use, your fuel injector can develop deposits that prevent them from metering fuel correctly. These deposits can cause inconsistencies in performance, poor fuel economy and runability problems with your sled. Our fuel injector cleaning service will remove the deposits and as an added benefit we will check the flow rate to ensure that it operates within its normal flow range. Both injectors must be sent for testing. ALL o-rings must be replaced. Learn More

For SLP Exhaust Systems Part #090-49 is used to attach the Trail Chef Cooker to the cooker mount on SLP PicNic'R Silencers. Learn More

Seals that are exact replacements for stock or SLP high performance exhaust systems. Sold per each. Learn More

This Pipe Upgrade Kit contains the pipe, y-pipe and all of the necessary hardware to upgrade one of our lightweight silencers that you previously purchased/installed to a complete pipe kit.   HINT: For easier y-pipe installation on 800 models we recommend the use of 6mm x 5” long 3/8” drive ball end allen (part# 20-221). For G4/G5 models we recommend using 6mm x 2"long drive ball end (Part #20-241). Instruction Sheets:
090-867P 090-807P Learn More

Less weight, proven horsepower and the SLP signature performance sound, just the right recipe for your 2012 600 RMK. Weight Reduction: 3.25 lb SAE J-2567 Tested Below 88 dB: ✔ See the link below for the Ultrablack High Temp Silicone Sealer necessary for proper installation. Learn More