Eliminate air intake restrictions by installing the Flow-Rite™ into the dash for more airbox feed. The Flow-Rite™ is supplied with a powder snow pre-filter that repels snow and water, yet passes air right through. A must for modified sleds. Sold per each.

Part #14-189: SLP part number 14-189 is made using a rubber flange to attach the Flow-Rite™ to the surface that it is being installed in. This rubber flange conforms itself to a wide variety of contoured, shaped and textured surfaces for a universal mounting system. This Flow-Rite™ has an outside diameter of 3 5/8" and requires making a 3 1/8" diameter hole for installation.

Part #14-194: SLP part number 14-194 is made using a rubber flange to attach the Flow-Rite™ to the surface that it is being installed in. This rubber flange conforms itself to a wide variety of contoured, shaped and textured surfaces for a universal mounting system. This Flow-Rite™ has an outside diameter of 2 11/16" and requires making a 2 3/8" diameter hole for installation.

Part #14-197: SLP part number 14-197 is designed for ease of installation on flat or nearly flat surfaces. It requires a 2 1/2" size hole saw which is readily available from any hardware store. Installation is a snap: hole saw the hole, debur the edges, clean hole saw shavings and snap Flow-Rite™ into place.

Note: Snap-In style Flow-Rites™ not recommended for belly pan installation. Use part #14-194 or 14-189 for installation in belly pan or chassis venting.

Note to help you choose correct part for your sled
Polaris Edge/IQ RMK/Switchback: 2" use part number 14-197
Polaris GEN II: 2 1/2" use part number 14-189
Ski-Doo ZX: 2" use part number 14-194
Yamaha Viper/SX/MM: 2 1/2" use part number 14-189 

 WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov